Disco 240 Dmx Controller Manual -

: Pressing this resets all DMX values to 000 across all channels. Press it again to resume your programmed settings. 2. Manual Operation To control lights manually without running a program:

Before you program, you must identify every physical control. Locate these sections on your board:

Provides real-time visual feedback on current DMX values, active banks, chase numbers, and step sequences. 2. DMX Channel Addressing and Allocation

Repeat the steps for other scenes, then hold for three seconds to exit. 🏃 Programming and Running Chases

If you’ve just bought one or are struggling with its interface, you’ve come to the right place. This article serves as a comprehensive guide, combining insights from official resources like the and the HD-240 Instruction Manual to answer all your questions.

To help customize this manual, could you tell me (e.g., LED par cans, moving heads) you are planning to connect, or if you need help mapping out the specific channels of your lights? Share public link

Adjust the fader to control how quickly the steps change.

Press the same buttons again. The LED above the pressed button will light up, indicating that you are now controlling that specific light fixture (e.g., Fixture 1).

Check if a blackout mode is active. If the Blackout LED is flashing, press the Blackout button to restore normal control. Alternatively, ensure your DMX line is properly terminated with a 120-ohm terminator at the final fixture to prevent signal reflection.

The Speed fader controls how long a step in a chase stays active. The Fade Time fader determines how smoothly the lights transition from one look to the next. Understanding DMX Addressing on the Disco 240

: Set each lighting fixture to a unique DMX starting address. For a standard 16-channel layout, Fixture 1 starts at 1, Fixture 2 at 17, and so on. Scene Creation Select the desired "Scanner" (fixture) button. Adjust the faders to set colors, positions, or patterns.