Hw 130 Motor Control Shield For Arduino Datasheet -

If you are not using servo motors, remain fully free for external sensors or components. Analog pins A0 through A5 are also fully exposed and available for analog sensor integration or digital input/output tasks. Power Management and the EXT_PWR Jumper

Here’s a concise review of the based on typical user documentation and datasheet content available for this popular low-cost Arduino shield.

Two 3-pin headers (labeled SER1, SER2) for standard hobby servos. hw 130 motor control shield for arduino datasheet

The 2-pin screw terminal block used to supply external power to the DC/Stepper motors. Never supply more than 25V. PWR Jumper (Disconnect Jumper):

: Output screw terminals for DC Motor 1 and 2, or Stepper Motor 1. If you are not using servo motors, remain

The HW-130 shield is designed to be stacked directly on top of an Arduino Uno or Mega. The following Arduino pins are used by the shield and should not be used for other purposes.

⚠️ The specific pin mapping can vary slightly between clones. However, the shield is almost universally compatible with the Adafruit Motor Shield V1 library ( AFMotor.h ), which handles these pin definitions automatically. Two 3-pin headers (labeled SER1, SER2) for standard

This shield is widely recognized for its versatility in small-to-medium robotics projects due to its ability to control multiple motor types simultaneously. L293D Based Arduino Motor Shield

The L293D chips can get hot. If you are drawing close to 600mA continuously, consider sticking a small aluminum heatsink onto the ICs. Conclusion