Xycd60 Manual Access

Voltage monitoring, power-saving mode, emergency stop. 2. Product Architecture and Interface The unit has four main interaction points:

: Long-press the DOWN button to toggle the screen's auto-off mode.

The is a highly versatile, microcontroller-based DC 6V–60V battery charge and discharge controller module . Operating primarily as an intelligent voltage-controlled relay switch, the device automates battery protection by preventing overcharging during its charging phase and preventing deep discharge during its depletion phase.

Connect a charger to the input and a battery to the output. xycd60 manual

If you're looking for additional resources or support, here are some options:

Note: The module is powered from the input side, so input voltage must be present for the unit to operate.

Note: The module uses an internal relay to break the circuit, acting as a smart switch. 3. Function and Parameter Settings (Menu Guide) Voltage monitoring, power-saving mode, emergency stop

| Goal | Recommended Action | | :------------------------------------ | :-------------------------------------------------- | | Protect a battery from overcharging | Use , charger on IN, battery on OUT | | Protect a battery from over‑discharge | Use P‑2 (Discharging Mode) , battery on IN, load on OUT | | Stabilise a system with voltage bounce | Increase dOP (delay‑on time) to 60–120 seconds | | Prevent false load disconnection | Enable FOP (forced‑on time) set to 3–5 seconds (discharge mode only) | | Use as a standalone charger | ❌ Not possible – the XY‑CD60 is a voltage‑controlled switch, not a charger | | Control a solar panel directly | ❌ Not possible – the XY‑CD60 cannot regulate charge current; it requires a dedicated charge controller |

Long‑press the DOWN button. Set L‑P to ON (auto‑off after 5–10 minutes) or OFF (backlight always on).

between the XY-CD60 and the XY-CD63L models. The is a highly versatile, microcontroller-based DC 6V–60V

| Specification | Details | | :-------------------------------- | :------------------------------------------- | | | XY‑CD60 / XY‑CD60L | | Supply Voltage | DC 6 – 60 V | | Maximum Load Current | 10 A (intermittent), 6 A (continuous) | | Voltage Measurement Accuracy | ±0.1 V | | Relay Type | SPDT mechanical relay | | Power Consumption | ~250 mW (30 mA operating) | | Operating Temperature | -40℃ to +85℃ | | Operating Humidity | 0% ~ 95% RH | | Module Dimensions (L×W×H) | 79 × 43 × 27 mm (3.11 × 1.69 × 1.06 in) | | Panel Cut‑out Dimensions | 71.3 (L) × 39 (W) mm |

After a charge or discharge cycle completes (relay turns OFF), the module will wait for seconds before the next cycle can begin. This gives the battery time to stabilise and prevents rapid relay chattering in unstable systems.

is and cannot alter voltage or limit current . Instead, it uses an onboard relay to mechanically connect or disconnect your power source or load based on your customized upper and lower voltage parameters. Technical Specifications Specification Operating Voltage DC 6V to 60V Control Precision Output Type Relay Output (Physical Switch) Supported Batteries Lead-Acid, Lithium-Ion, LiFePO4, etc. Power Consumption < 1.5W (Approx. 30mA operating current) Physical Dimensions ~79mm x 43mm x 27mm Core Operating Modes

Sets the time duration for charging or discharging (00:00 - 99:59 hours).